Our R&D Portfolio - Case Studies
(A sneak peek into our previous work)
Advanced Power Architecture
Off-the-shelf power supplies fail when your system demands custom battery chemistries, high-efficiency step-downs, or smart telemetry.
We engineer specialized power electronics — from hundreds of watts of programmable charging to high-efficiency DC-DC converters — ensuring rock-solid stability and parameters to meet your specific needs.
We handle the Power Delivery Integration with our modules with digital data communication for convenient system monitoring.
Where customization is needed we can integrate your specific circuit, MCU, sensor, BMS requirement to the Power Bank Module design we have.
Data Interfaces & Communication
Stock data interfaces and converters are good until you need just a slight customization to fit better for your needs. Every application has its own specific requirements and different power, protocol and form-factor parameters are often required.
We engineer specialized data interfaces, data converters, industrial PC Main Boards (Hubs).
Our unique expertise lies in the STM32 (or other MCU) Ethernet integration, even with Ethernet Switch embedded right on the board. Many different port counts, up to Gigabit link speeds.
We specialize in USB Data Exchanges, especially with Virtual Network Link right over USB.
We can provide a convenient API for your data right over a single USB, where it is more convenient than classic Ethernet.
We focus on STM32 Microcontrollers and ESP32 Wireless MCU Modules integration.
Display Interface & HMI
We provide STM32-based display modules for either big 7″ RGB Interfaced panels or a generic boards with any display compatibility via I2C, SPI, RGB interfaces.
On-board literally any multimedia feature and I/O you can imagine. See the parameters:
- STM32H7 MCU
- RGB666 Interface
- I2C Touch
- DRAM 8-32MB
- NOR FLASH 4-32MB
- SD Card
- Ethernet (PoE Ready)
- USB
- Haptic Feedback
- RGB LED Output
- Audio Amplifier Output
- RS-485
- EEPROM
- Power Management for single-cell Lithium (Charger)
- Backlight SMPS
- LCD Power SMPS
Small Electronics & IoT
We are not afraid of tiny electronics with very low power consumption. We designed our own E-Paper module on an affordable 4-color E-Paper panel. We provide either a bare module with SPI control, an ESP32 NanoPower controlled one or a customized version.
We provide the tiniest FCC pre-certified Arduino Nano form-factor ESP32 board with battery backup.
Using the ESP32 PICO SIP (One package fits the MCU, Flash, DRAM) and a complex one cell Lithium battery power management it provides the ultimate UPS solution in the tiniest form.
Specialized, High-End Research & Development Projects
We have worked on highly specialized, high-performance Analog Front-End and DSP-related projects.
Solid State X-Ray Detectors are very susceptible to noise and interference. They also provide very fast signal response (pulses). We integrated the AFE with a very high-speed 16-bit ADC in the STM32H7 MCU.
Simulations for the power amplifier response are a must, before the actual electronic and firmware (controller, DSP) design takes place.